How To Fix LG Washer Won’t Drain or Keeps Draining (Repair Guide)

LG washers are known for their high quality and efficiency. However, sometimes they won’t drain completely or stop mid-cycle.

This article will give you a step-by-step guide for fixing LG Washer that Won’t Drain / Keeps Draining. The article will also cover the steps that you can take to prevent the issue from happening again.

Why is LG Washer Won’t Drain or Keeps Draining

 

The LG washer won’t drain is a common problem faced by many people. There are many reasons behind this issue and can be fixed in a few simple steps.

LG washer won’t drain is a common problem faced by many people. Some of the reasons behind this issue are as follows:

1. The drain pump might be clogged with debris that has accumulated over time
2. The pump might have failed
3. The water pressure might be low due to an inadequate water supply or insufficient supply of water to the machine
4. The machine might not have been installed correctly or it could have been installed in an area with low water pressure.

 

How to Fix LG Washer Won’t Drain / Keeps Draining

 

One of the most common problems that LG washer owners face is clogged hoses. It can happen when the hose gets clogged with a small pebble or dirt and it becomes difficult for water to flow through.

To fix the LG washer won’t drain, follow these steps:

• Turn off your washer by unplugging it from its power source. This will also turn off any other electrical appliances plugged into the same power source.
• Remove the hoses from your machine and clean them with a brush and soapy water. Make sure you remove all debris from the connector areas as well.
• Put back the hoses onto your machine and check.

 

METHOD TWO

 

This is an issue that many people have faced with their LG washer. The issue is that the machine won’t drain and keeps draining.

If this is because the water pump has failed and needs to be replaced.

The water pump can be replaced by following these steps:

1. Remove the front panel of the washer using a flathead screwdriver.
2. Disconnect the power cord from the outlet and remove it from the wall socket.
3. Using a large wrench, loosen both nuts on each side of the water pump assembly (one on top, one on bottom). Then, remove it from its mounting bracket.
4. Replace with new water pump assembly and re-assemble washer back together.

 

METHOD THREE

 

If you’re having these issues with your LG washer, here are some tips on how to fix it.

• Unplug the appliance and let it sit for a few minutes before plugging back in.
• Check if the water level is too high in the tub by removing the lid and checking if there is a lot of water inside.
• Check if anything is blocking the drain, such as hair or other debris that might be clogging it up.
• Clean the drain filter of any debris with a toothbrush and warm soapy water.

 

How to Drain Water From LG Washing Machine Top Load

 

 

A common problem with the LG washing machine is the water that gets stuck in the top load, and it’s hard to drain. This article will provide you with a few tips on how to get rid section the water.

Tips:

1. Make sure you are using cold water when draining out the water from your LG washing machine.
2. Make sure your machine is completely dry before putting in any clothes or detergent again.
3. Use a plunger or something else to get rid of the remaining residue left behind by the detergent or other substances that may be clogging up your top load washing machine’s drainage system.

 

How to Drain LG Inverter Direct Drive Washer

 

This is a guide on how to drain LG inverter direct drive washer.

Lg Inverter Direct Drive Washer:

 

How to Drain the LG Inverter Direct Drive Washer:

1. Remove the front panel of the washing machine.
2. Find the rubber hose that is connected to a drain valve located on the bottom of your washing machine.
3. Make sure that you have turned off your washing machine by pressing and holding down both buttons on top of it for at least 10 seconds.
4. Connect a hose with a small diameter nozzle and place it into the drain valve opening from below, then close it with your hand or foot so that water flows out from it to avoid any damage caused by water pressure inside your washing machine’s drum

 

How Do I Reset my LG Washing Machine?

 

 

Here are some simple steps you can follow to reset your LG washing machine.

1. Unplug the appliance and leave it unplugged for a few minutes
2. Remove the door of the machine
3. Pop-out the motor and place it in a bucket of water so that it can cool down
4. Remove any screws that might be holding the lid in place and remove it
5. Place the lid back on top of your machine, plug it back in, and turn it on.

 

MORE GUIDES:

How To Fix Dishwasher Red Light Flashing (Repair Guide)

How To Fix Whirlpool Washer Repeating Cycle, Keeps Draining, Shuts Off, Not Working

How To Fix Samsung Washer Won’t Lock/Won’t Unlock

How To Fix Samsung Washer Not Starting/Stopping

How To Fix Kenmore Washer Won’t Drain/Keeps Draining/Drain Cycle Problems

How To Fix Bosch Dishwasher Not Cleaning

How To Fix LG TV Menu Not Working (Repair Guide)

 

Video Guide

 

 

 

 

Conclusion

 

The LG Washer Won’t Drain / Keeps Draining is a common problem faced by many people. This is because the drain hose can get clogged due to the build-up of hair, lint, or other material.

There are many ways to fix this issue. You can use a wire coat hanger or a toothbrush to clean out the drain hose. You can also use an appliance cleaner such as CLR or PBW to remove the build-up from your drain hose.